Tap
Roll over image to zoom in Click on image to zoom
Tap

Image may not reflect complete product dimensions and specifications. Please call to confirm any questions.

#10-32 UNF CS Spiral Point Tap | 6" OAL | Uncoated (Bright) | DWTGT6X10-32 (2 / Pkg.)

Drill AmericaSKU: DWTGT6X10-32
Price:
$33.70per 2( $16.85 each)
Pieces 2
Measurement type Inch
Thread size #10
Diameter #10
Length 6"
Material Carbon Steel
Finish Uncoated (Bright)
Flute length 7/8"
Point type Spiral Point
Shank size 0.194"
Threads per inch 32
Weight 2.0 lb

WARNING: This product can expose you to chemicals including lead and lead compounds, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to https://www.P65Warnings.ca.gov.

Description

#10-32 UNF CS Spiral Point Tap for tapping recessed and hard-to-reach holes. An extended shank puts the cutting section well ahead of the drive, reaching threads recessed below a surface or down inside a bore. This size has a #10 cutting diameter, 7/8" of flute, 6" overall length and a 0.194" shank.

  • Carbon Steel construction that suits hand use and softer material where cutting speeds stay low.
  • Uncoated (Bright) finish, leaves the edge bare for free cutting.
  • Spiral Point geometry.
  • #10 thread at 32 threads per inch.
  • Supplied 2 per package.

Specifications

  • Size: #10-32
  • Thread Size: #10
  • Threads per inch: 32
  • Diameter: #10
  • Shank Size: 0.194"
  • Length: 6"
  • Flute Length: 7/8"
  • Point Type: Spiral Point
  • Material: Carbon Steel
  • Finish: Uncoated (Bright)
  • Measurement Type: Inch
  • Pack Quantity: 2

Applications

For tapping at the bottom of deep counterbores, inside housings and in any hole a standard tap cannot reach.

Can We Help?

If you’re not sure that this product is right for you, give us a call!
800-222-0324

Recently viewed